Default welcome msg!
Brief Introduction: This Kit includes a tiny Edison fits nicely onto a breakout board - sort of like a tiny IoT sparrow into a very small nest, so you can expose the native 1.8 V I/O of the Edison. And it is for non-Arduino users. This breakout board has a minimalistic set of features and is slightly larger than the Edison module. Dimensions：61mm x 29mm x 12mm Main Features: Uses a 22nm Intel® SoC that includes a dual core, dual threaded Intel® Atom™ CPU at 500MHz and a 32-bit Intel® Quark™ microcontroller at 100 MHz. It supports 40 GPIOs and includes 1GB LPDDR3, 4 GB EMMC, and dual-band WiFi and BTLE on a module slightly larger than a postage stamp. The Intel Edison module will initially support development with Arduino* and C/C++, followed by Node.JS, Python, RTOS, and Visual Programming support in the near future. It includes a device-to-device and device-to-cloud connectivity framework to enable cross-device communication and a cloud-based, multi-tenant, time-series analytics service. The breakout board has exposes native 1.8V I/O of edison module. And 0.1'' grid I/O array of through-hole solder points. USB OTG with USB Micro Type-AB connector, USB OTG power switch. Battery Charge, USB to device UART bridge with USB Micro Type-B connector, DC power supply jack (7V – 15V DC input). Specification: Physica Form factor Board with 70-pin connector Dimensions 61mm x 29mm x 12mm Operating temperature 0 to 40 degC Connector Hirose DF40 Series (1.5mm, 2.0mm, or 3.0mm stack height) Memory Max Memory size 4GB Memory type DDR3, Nand Flash Physical add. Ext. 32-bit # of DIMMs 0 ECC Memory supported: NO External Interfaces Total of 40 GPIOs which can be configured as: SD Card 1 Interface UART 2 Controllers I2C 2 Controllers SPI 1 Controller with 2 chip selects I2S 1 Controller GPIO Additional 12 (with 4 capable of PWM) USB 2.0 1 OTG Controller Clock Output 32 KHz, 19.2 MHz Major Edison Components SoC 22nm Intel SoC includes: a dual core, dual threaded Intel Atom CPU at 500MHz, and a 32-bit Intel Quark microcontroller at 100 MHz RAM 1 GB LPDDR3 POP memory Flash Storage 4 GB eMMC WiFi Broadcom 43340 802.11 a/b/g/n Dual-band (2.4 and 5 GHz) On board antenna or external antenna SKU configurations Bluetooth BT 4.0 Power Input 3.3V – 4.5V Output 100ma @3.3V and 100ma @ 1.8V Power Standby (No radios): 13mW Standby (BT 4.0): 21.5mW Standby (WiFi): 35 mW Firmware + Software CPU OS Yocto Linux v1.6 Development Environments Arduino IDE Eclipse supporting: C, C++ & Python Intel XDK supporting: Node.JS & HTML5 MCU OS RTOS Development Environments MCU SDK and IDE Tech. Documents: Intel Edison Product Page Intel Edison Product Brief Getting Start Software Download Forum Support Related Products: Intel® Edison Module Intel® Edison Kit for Arduion Intel® Gelileo Intel® Gelieo Gen 2 USB Console Adapter for Intel Galileo Grove starter kit plus – Intel IoT Edition for Intel Galileo Gen Grove starter kit plus – Intel IoT Edition for Intel Galileo Gen 1 Galileo Case